Filter
Top Products
30
LK3-B448E MARKII/BA-16
7. Correct use
Do not touch or place anything against any of the moving parts while winding the lower thread, otherwise
personal injury or damage to the machine may result.
8. To wind more thread onto
the bobbin, loosen the set
screw t and pull the bob-
bin presser q outward.
1. Place the bobbin all the way onto the shaft.
2. Thread the thread as shown in the illustration at right,
wind the thread around the bobbin several times in
the direction of the arrow, and then press the bob-
bin presser q.
3. Turn on the power switch.
(The POWER indicator on the operation panel will
illuminate.)
4. Check that the button is not inserted and the needle does not
touch the button clamp, and then while pressing the BOBBIN.
WIND switch w, depress the foot switch e to start the ma-
chine. Keep depressing the foot switch e until the lower thread
stops being wound onto the bobbin.
Release the BOBBIN. WIND switch w after the machine starts
operating. If you release the foot switch before winding is com-
pleted, depress it once more while pressing and holding the BOB-
BIN. WIND switch w.
7. Remove the bobbin,
hook the thread onto the
knife r, and then pull the
bobbin in the direction of
the arrow to cut the
thread.
6. Release the foot switch e.
5. The bobbin presser q will automatically return to its original position after a set amount of thread (80 - 90% of the
bobbin capacity ) has been wound on.
q
BOBBIN.WIND
e
w
Case A
Case B
CAUTION
7-4 . Winding the lower thread
<< If the thread winds onto the bobbin unevenly >>
If the thread winds onto the bobbin unevenly, loosen the
nut q and turn the bobbin winder thread tension stud w
to adjust.
* If the thread winds on as shown in A, turn the bobbin
winder thread tension stud w clockwise; if it winds on
as shown in B, turn the bobbin winder thread tension
stud w counterclockwise.
w
q
q
t
r