Filter
Top Products
7. SEWING
RH-9800
41
3. Press the "up" button (L) or the "down" button (K) until
the desired number of home position cycles is
displayed.
The setting range is between 0 and 9.
* If the number of home position cycles is set to "5",
returning to the home position will occur once for
every five cycles.
However, when carrying out cycle sewing, the
machine will return to the home position once for
each cycle program regardless of the number of
home position cycles which have been set (unless
the setting is "0").
Normal home position cycling will not be carried out
if the setting is "0".
4. Press the ENTER button (N) to accept the home
position cycle setting. This setting will apply to all
program numbers from 1 to 9.
* The display will stop flashing and will start
illuminating steadily.
Note: If for some reason an excessive load is applied to the feed bracket which causes it to slip, then there is the
danger that this will have an adverse effect on subsequent sewing operations. Therefore, it is recommended that
you return to the home position for each cycle (i.e. that you leave DIP switch No. 8 on the circuit board set to
OFF).
7-13. Returning to the home position
This is useful for correction purposes when mistiming occurs in the home position cycle because re-sewing was carried
out.
* This function is only valid when DIP switch No. 8 on the circuit board is set to ON.
1. When at the home position in AUTO mode, press the
RESET button (1) to start sewing from the home
position.
(J)
(K)
(M)
(L)
(N)
1171Q
(1)
1189Q