Filter
Top Products
6. USING THE OPERATION PANEL AND FRONT PANEL
RH-9800
27
6-6. Using the memory switch
The conditions of the memory switches are memorized even if the power is OFF, however, if data of the memory
switches are initialized, the memory switches will be returned to their initial settings (factory default settings).
1. While pressing the SELECT button (M), press the power switch to turn on the power.
* The two left-side columns of the front panel display (J) are the memory switch number, and the two right-side
columns show the memory switch setting (or value).
2. Press the SELECT button (M) to select the desired memory switch number.
* The setting range is from 00 to 99. However, numbers in unused ranges are skipped.
3. Press the “UP” button (L) or “DOWN” button (K) to select the desired memory switch number.
* For memory switches which can be set to ON or OFF, press the "UP" button (L) to set to "On", and press the
"DOWN" button (K) to set to "OF". "On" represents ON, and "OF" represents OFF.
4. Press the ENTER button (N) to store the memory switch setting.
5. Press the MODE button (1).
* The TROUBLE indicator will flash and the sewing machine will go to normal standby mode.
No. Contents Setting range
Initial
value
00 Bar tacking at the sewing start to prevent fraying
OFF: Disabled
ON: Enabled
OFF
01
Number of stitches for memory switch No. 00
* Does not appear when memory switch No. 00
is set to OFF.
01: 1 stitch
02: 2 stitches
03: 3 stitches
01
02 Bar tacking at the sewing end to prevent fraying
OFF: Disabled
ON: Enabled
OFF
03
Number of stitches for memory switch No. 02
* Does not appear when memory switch No. 02
is set to OFF.
01: 1 stitch
02: 2 stitches
03: 3 stitches
01
04
Work clamp operation selection when feed
bracket is at front position
(Set to OFF if the cutting block may strike the
Work clamp.)
OFF: The work clamp passes underneath the cutting
block, then rises and moves forward.
ON: The work clamp rises and then moves
forward.
OFF
05 Eyelet buttonhole sewing speed setting
OFF: Same speed as speed A set at the front panel.
ON: Different speed from speed A set at the front
panel.
OFF
06
Speed for memory switch No. 05
(If the speed is set to a higher value than
speed A that has been set at the front panel,
the speed will not exceed speed A.)
* Does not appear when memory switch No. 05
is set to OFF.
10: 1,000rpm, 11: 1,100rpm, 12: 1,200rpm,
13: 1,300rpm, 14: 1,400rpm, 15: 1,500rpm,
16: 1,600rpm, 17: 1,700rpm, 18: 1,800rpm,
19: 1,900rpm, 20: 2,000rpm
18
(J)
(L)
(N)
(K)
(M)
(1)
1019Q
1160Q