Filter
Top Products
7. SEWING
RH-9800
37
7-7. Setting the feed bracket to the front position
Setting the material will be easier if the feed bracket is moved forward from the standard cloth setting position.
* Cycle time will be reduced with this setting, particularly if cutting after sewing is selected.
1. Turn off the power.
2. Set DIP switch No. 3 inside the front panel.
3. Turn on the power.
4. Press the RESET button (1).
5. The feed bracket will move to the front position.
6. Sewing can then be carried out as normal. (Refer to
page 30.)
7-8. Switching between single-pedal and dual-pedal operation
(Switching the foot controller)
The cloth presser can be lowered and the machine can start sewing just by pressing the start switch, without having to
use the cloth presser switch.
1. Turn off the power.
2. Change the setting of DIP switch No.5.
OFF: To use both pedals (cloth presser switch and
start switch)
ON: To use only one pedal (start switch)
3. Turn on the power and press the RESET button (1).
Sewing can then be carried out as normal.
Note: During single pedal operation, when the start
switch is pressed, the cloth presser is lowered
and sewing starts straight away.
1178Q
1179Q
1180Q
(1)
1179Q
1180Q
(1)
1181Q