Filter
Top Products
7. SEWING
RH-9800
40
7-11. Changing the cycle program counter
The cycle program counter can be easily changed if necessary, for instance because re-sewing was necessary.
1. If carrying out cycle sewing in AUTO mode, switch the
contents shown in the front panel display from the
production counter to the cycle program.
The program number which is to be sewn next will
flash in the display. To change the cycle program
counter (the position where the display is flashing),
press the "up" button (L) or the "down" button (K) to
make the desired setting.
* If you would like to switch the display from the cycle
program to the production counter, press the
SELECT button (M). The production counter will be
displayed while this switch is being pressed.
7-12. Setting the number of home position cycles
The number of home position cycles can be set in order to shorten the overall cycle time.
* This function is only valid when DIP switch No. 8 on the circuit board is set to ON.
1. Press the MODE button (1) to switch to program
mode.
2. Press the SELECT button (M) so that "HP" is
displayed in the front panel display.
* The display will change in the following order each
time the SELECT button is pressed:
→A → B
P4 → HP
(Continued on next page)
1186Q
1185Q
(L)(K)
(M)
(J)
(1)
1188Q
1187Q