Filter
Top Products
3. INSTALLATION
RH-9800
4
3-2. Installing the motor
1. Insert the three bolts (1) into the work table.
2. Turn the work table upside down to make it easier to
install the motor (2).
3. Align the motor (2) with the bolts (1), and then install
the motor (2) to the underside of the work table with
the three washers (3) and the three nuts (4).
Note: Do not use the cushion rubber. If you use it, V
belt tension cannot be adjusted.
3-3. Installing the machine head
1. Insert the accessory bed stand cushions A (1) into the bed stand, and then place the machine head on top of the work
table.
Note: When placing the machine head on top of the work table, have two or more people there to hold the handles A
and B and the rear of the head C.
2. Open the front cover (2), and then use the bed stand mounting bolt (3), washer (4), cushioning rubber (5), bed stand
cushion A (1), large washer (6) and nut (7) to attach the front right corner of the bed stand to the work table.
3. Open the rear cover (8), and then attach the bed stand to the work table in two places inside the stand in the same
way as in step 2. above.
4. Remove the fixing bolt (9) and the washer.
Note: The fixing bolt (9) and washer should be kept, as they will be needed again if the machine head is moved.
5. Raise the machine head, and then attach the front left corner of the bed stand to the work table in the same way as in
the steps above.
Note: Make sure that steps 2. to 4. above have been completed before raising the machine head.
(2)
(4)
(3)
(1)
1098Q
(3)
(4)
(5)
(2)
(9)
(1)
(7)
(1)
(3)
(4)
(5)
0808Q
(6)
(8)
(6)
(7)
1099Q