Filter
Top Products
IMPORTANT NOTICES
A qualified gas engineer must carry out the
installation and servicing of this appliance in
accordance with these instructions and in
compliance with current Building Regulations.
Such person must be a registered CORGI
engineer.
This appliance is designed to run on natural gas or
LPG, however it is not possible to change between
the two versions without a factory service.
Warning - Only use the appliance with the spec-
ified gas (see the appliance data plate).
This appliance is intended for use on a gas installa-
tion with a governed meter.
The instructions must be read before use of the
appliance.
Please note the following;
• Sealed components must not be interfered
with.
• Servicing instructions and part identification
numbers are given towards the back of the
manual.
• Only use genuine Aarrow parts for
replacements.
All surfaces except the control knobs are
considered to be working surfaces.
Please note, that the monitoring system (ODS)
operates if evacuation of the combustion products
is interupted. If this does occur, turn the appliance
to the fully OFF position, and re-light (see page
32). If this monitoring system continues to cut out
the appliance, a qualified gas engineer should be
called.
Warning: Under no circumstances must the
stove be operated if the glass is cracked or
broken.
Warning: If it is known or suspected that an
operational or ignition fault exists on the
appliance, it must not be used until it has been
investigated and corrected by a qualified gas
engineer.
Warning: The stove will become very hot. Always
use a fire guard in the presence of children, the
elderly, and the infirm. The fireguard must
comply with BS8423:2002 (Fire guards suitable
for use with solid fuel appliances).
Warning: No combustible materials including
clothing, furniture and furnishings (including
curtains) must not be placed within 1 metre of the
stove.
Warning: THIS GAS APPLIANCE MUST BE
SERVICED EVERY TWELVE MONTHS BY A
QUALIFIED GAS ENGINEER.
STATUTORY REQUIREMENTS
This product must be installed in accordance with
the rules in force.
The current Gas Safety (Installation and Use)
Regulations (as amended).
The Building Regulations for England and Wales
2000 ref Approved Document J 2002 edition
(issued by the DTLR).
The Building Standards (Scotland) (Consolidation)
Regulations.
Detailed recommendations are outlined in the
current issue of the following British Standards:-
BS5440 parts 1 and 2, BS5871 part 1 and BS6891
.
Any Manufacturer Instructions must not be taken
as overriding statutory requirements.
_________________________________________
CERTIFICATION
This appliance is CE certificated for performance
and safety. Therefore, it is important that no
alteration is made to the appliance.
Any alteration not approved by Arada Ltd will
invalidate the guarantee.
38 Aarrow Sherborne GSL CF
USER INSTRUCTIONS