Filter
Top Products
ASSEMBLE MOTOR
1) Remove the front cover from the valve. This is done by unscrewing the small pozi screw, located by
knob B. Unclip the right hand side of the cover located to the side of knob A. See Fig. 16a & b.
2) Remove the cover and dispose of the spacer tube fitted with the screw.
3) Position the motor onto the location lugs (arrow X) and engage the drive gear onto knob B (arrow Y).
4) Replace valve cover, ensure clip is located before the pozi screw is tightened. Do not over-tighten the
screw as this may effect the operation of the control.
5) Take the micro switch and fix to the front of the valve cover with the self tapping screw provided.
Switch is located onto the lug moulded within the valve cover, next to knob B. See Fig. 16e.
Aarrow Sherborne GSL CF 19
INSTALLATION INSTRUCTIONS
Fig. 16a Fig. 16b
Fig. 16d
Fig. 16c
X
Fig. 16e
Knob A
Knob B
Screw
Tab
Y
Knob B
Wiring
Connections
Micro Switch