Filter
Top Products
Manual Mode (Man in Display) for Manual Flame Height Adjustment
• Press ( A ) to turn on the fire (main burner) or to increase flame height.
• Press ( B ) to decrease the flame or to turn down to pilot.
• To incrementally increase or decrease the flame height lightly tap either the ( A ) or ( B ) button.
• The “Send” symbol appears in the upper left corner of the display when either large button is depressed.
• The LED of the remote control reciever flashes when knob B of the valve reaches its end stops.
Automatic Mode (AUTO in display) for Temperature Control
• Briefly press AUTO. The set temperature will appear briefly before the display reverts to the room temperature.
Timer Mode (TIMER in display)
• During heating periods P1* and P2* the temperature is continued in the same manner as in automatic mode.
• When the timer programme turns to P1) or P2) (heating cycle off) the motor will turn the valve to pilot and there is
no temperature control. This minimizes battery consumption.
• You may press AUTO to verify the set - temperature and then press TIMER to return to timer mode.
• You may press either the ( A ) or ( B ) button from any mode for manual override.
• To prolong battery life we recommend switching the remote control to manual mode and turning the fire to pilot
with the ( B ) button before turning the appliance off. If the remote control is left in automatic or timer mode, the
batteries will continue to be used when the appliance is off.
Changing the Battery
• If BATT appears in upper right hand corner of the display or if the red light of the receiver becomes faint please
change the battery from remote control or receiver.
Slide back the handset battery compartment cover, remove the used battery, insert and connect a suitable battery (9V-
6F22) and replace the cover.
36 Aarrow Sherborne GSL CF
USER INSTRUCTIONS
Fig. 22