Filter
Top Products
THERMOSTAT AND TIMER REMOTE CONTROL
TRANSMITTER FUNCTIONS
Set the display (from *C/24 h to *F/12 h and vice versa)
• After connecting the battery or by simultaneously pressing AUTO and TIMER, the display flashes you
are in set mode.
• From set mode, press AUTO to switch from *F (and 12 hour clock) to *C (and 24 hour clock)
• The display will automatically return to manual mode after some time, but you may immediately return
ual by depressing the TIMER button.
Set the current time
• After connecting the battery or by simultaneously pressing AUTO and TIMER, the display flashes you
are in set mode.
• From set mode, press ( A ) to set the hour and ( B ) to set the minute.
• Wait or press TIMER to return to “manual” mode.
Programming the Desired Set Temperature
• Press AUTO until the display flashes
• Press ( A ) or ( B ) to the desired temperature.
• Wait or press AUTO to switch to automatic mode.
• A sensor in the remote control measures the room temperature. The controller compares the room temper-
ature with the set temperature and sends a signal to the receiver to turn the gas valve motor, which adjusts
the flame height accordingly.
Programming the Timer
• Press TIMER until P1* (start) flashes (period 1. heating cycle on).
• Set the time for the beginning of the first heating period by pressing ( A ) for hour and ( B ) for minute.
• Press TIMER again P1* disappears and the symbol P1) (finish) appears.
• Set the time for the end of the first heating period.
• Press TIMER again to set the second heating period P2* (start) and P2) (finish).
• Store both heating periods by pressing TIMER again.
NOTE! If only one heating period is desired, programme the same time for P2* and P2) as for P1* and
P1).
Aarrow Sherborne GSL CF 35
USER INSTRUCTIONS