Filter
Top Products
3
Please Do Not Return This Product To The Store. Contact your local Wayne-Dalton dealer. To find your local Wayne-Dalton dealer, refer to your
local yellow pages/business listings or go to the Find a Dealer section online at www.wayne-dalton.com
Package Contents
(1)TORQUEMASTER
®
SPRING TUBE
1/4”-14 X 5/8” SELF TAPPING
SCREWS (AS REQUIRED)
1/4”-20 X 11/16” SELF DRILLING
SCREWS (AS REQUIRED)
DOOR SECTIONS (AS REQUIRED)
(2) 3/8”-16 X 3/4”
TRUSS HEAD BOLTS
(1) CENTER BRACKET
ASSEMBLY
(2) VERTICAL
TRACKS RH/LH
(2) FULLY ADJUSTABLE RH/LH
FLAGANGLES (AS REQUIRED)
5/16” X 1 5/8” LAG SCREWS
(AS REQUIRED)
WEATHER SEAL & NAILS
(IF INCLUDED)
1/4”- 20 FLANGED HEX
NUTS (AS REQUIRED)
DRUM WRAPS
(1) RIGHT & (1) LEFT
PULL ROPE
(IF INCLUDED)
(2) QUICK INSTALL RH/LH
FLAGANGLES (AS REQUIRED)
(1) LOOSE WINDING SHAFT
(SINGLE SPRING ONLY)
5/16” X 18 X 3/4”
CARRIAGE BOLTS
(AS REQUIRED)
(2) 5/16”HEX NUTS
CABLE DRUM ASSEMBLIES
(1) RIGHT & (1) LEFT
(2) HORIZONTAL TRACKS RH/LH
NOTE: DEPENDING ON THE DOOR MODEL, SOME PARTS LISTED WILL NOT BE SUPPLIED IF NOT
NECESSARY. REAR SUPPORTS MAY NOT BE INCLUDED WITH YOUR DOOR.
ROLLERS
(AS REQUIRED)
(2) HORIZONTAL ANGLES
(21-15/16” OR 80”)
(AS REQUIRED)
U-BARS
(AS REQUIRED)
Q.I. JAMB BRACKETS
(AS REQUIRED)
(2) 3/8”- 16 HEX NUTS
END BRACKETS
(1) RIGHT & (1) LEFT
WARNING
Rachet Bracket is under
EXTREME SPRING TENSION.
To avoid possible severe or
fatal injury, DO NOT remove
fasteners from ratchet bracket
until spring(s) are fully
wnwound.
To safely unwind spring(s) read
and follow the directions in the
installation instructions/owners
manual.
DO NOT REMOVE THIS TAG.
P/N 300547
WARNING
Rachet Bracket is under
EXTREME SPRING TENSION.
To avoid possible severe or
fatal injury, DO NOT remove
fasteners from ratchet bracket
until spring(s) are fully
wnwound.
To safely unwind spring(s) read
and follow the directions in the
installation instructions/owners
manual.
DO NOT REMOVE THIS TAG.
P/N 300547
5/16”X 1-1/4” CLEVIS
PIN & COTTER PIN
STUDPLATE
(IF INCLUDED)
OPERATOR BRACKET
LIFT HANDLES
PULL HANDLES
#10 X 5/8” PAN HEAD SELF
TAPPING SCREWS (BLACK
PAINTED HEADS)
PRE-INSTALLATION
1/4” - 20 X 9/16”
TRACK BOLTS
ROLLER SLIDE
(AS REQUIRED)
(2) TOP ROLLER SLIDE
JBUS JAMB BRACKETS
(AS REQUIRED)
1/4”-14 X 7/8” SELF
DRILLING SCREWS
WINDLOAD LABEL
1/4”-20 X 5/8”
CARRIAGE BOLTS
1/4”-14 X 5/8” SELF
DRILLING SCREWS