Filter
Top Products
Tools Needed:
24
Tools Needed:
Please Do Not Return This Product To The Store. Contact your local Wayne-Dalton dealer. To find your local Wayne-Dalton dealer, refer to your
local yellow pages/business listings or go to the Find a Dealer section online at www.wayne-dalton.com
Place vice clamps onto both vertical
tracks just above the third roller. This is
to prevent the garage door from raising
while winding the counterbalance
springs.
FAILURE TO PLACE VICE
CLAMPS ONTO VERTICAL
TRACKS CAN ALLOW DOOR TO
RAISE AND CAUSE SEVERE OR
FATAL INJURY.
Securing Door
for Spring Winding
TRACK
Vice Clamps
WARNING
24
PLACE VICE
CLAMPS ABOVE
3RD ROLLER
Check to ensure the cable is aligned
and seated in the first and second
groove of the cable drum. Snug the set
screw, and then tighten an additional
1-1/2 turns.
IMPORTANT: ENSURE THE CABLE IS
ALIGNED AND SEATED IN THE FIRST
GROOVE OF THE CABLE DRUM PRIOR TO
WINDING SPRINGS.
Measure approximately 6” of cable and
cut off excess cable. Insert end of cable
in hole of cable drum.
NOTE: Illustrations show the right
TorqueMaster
®
Plus drum, left
TorqueMaster
®
Plus drum is
symmetrically opposite.
25
Cable Adjustment
Vice Grips
Pliers/Wire
Cutters
Flat Tip
Screwdriver
Step Ladder
6”
FIRST AND
SECOND
GROOVE
SET SCREW
RIGHT HAND
DRUM
CAM PEAK
1-1/2 WRAP
CABLE DRUM HOLE
VICE CLAMPS
ATTACHED TO
TRACK