Filter
Top Products
Tools Needed:
11
Please Do Not Return This Product To The Store. Contact your local Wayne-Dalton dealer. To find your local Wayne-Dalton dealer, refer to your
local yellow pages/business listings or go to the Find a Dealer section online at www.wayne-dalton.com
INSTALLATION
PULL HANDLE PLACEMENT REFERENCE ON DOUBLE WIDE DOORS
6
Tape Measure
Pencil
Power Drill
1/16” Drill Bit
Pull Handle Installation
BOTTOM
SECTION
LOCATE THE CENTER
(2) #10 X 5/8”
PAN HEAD
SELF TAPPING
SCREWS
PULL HANDLE
BOTTOM
SECTION
PULL HANDLE PLACEMENT REFERENCE ON SINGLE WIDE DOORS
On single doors, locate and mark the
horizontal and vertical center on the
bottom rail of the bottom section.
Center the pull handle using the vertical
and horizontal lines as reference on the
bottom section rail as shown. Using the
pull handle as a template, mark the two
holes in the pull handle on the horizontal
line of the bottom section rail. Drill a
1/16” pilot hole, then fasten pull handles
using (2) #10 X 5/8” pan head self
tapping screws.
NOTE: Reference illustrations for pull
handle positions on single and double
car garage doors. If your door came with
two pull handles they must be installed
as shown in the bottom illustration.
8” MAX.
BOTTOM OF THE DOOR