Filter
Top Products
21
Tools Needed:
Tools Needed:
Please Do Not Return This Product To The Store. Contact your local Wayne-Dalton dealer. To find your local Wayne-Dalton dealer, refer to your
local yellow pages/business listings or go to the Find a Dealer section online at www.wayne-dalton.com
20
Center Bracket Bushing
NOTE: If you are installing the idrive
®
opener with your garage door, skip this
step and go to your idrive
®
Installation
Instructions and Owner’s Manual. After
completing steps 1-13 of your idrive
®
Installation Instructions and Owner’s
Manual, rear supports will need to be
fabricated/installed to support both
horizontal tracks, see step 28.
NOTE: If you are not installing the
idrive
®
opener on your garage door, you
must install the center bracket bushing
assembly. Follow these instructions for
non-idrive
®
operated garage doors.
Being cam shaped the center bracket
bushing only fits one way.
Slide the center bracket assembly
towards the center of the TorqueMaster
®
spring tube, from the right side as shown.
CENTER
BRACKET
ASSEMBLY
TORQUEMASTER
®
SPRING TUBE
TORQUEMASTER
®
SPRING TUBE
CENTER
BRACKET
BUSHING
INSTALLATION
21
IMPORTANT: RIGHT AND LEFT HAND
IS ALWAYS DETERMINED FROM INSIDE
THE GARAGE LOOKING OUT.
Drum wraps are identified as right hand and left
hand.
Slide the left hand drum wrap over the left side
of the TorqueMaster
®
spring tube assembly
with the tabs facing left. Continue sliding the
left hand drum wrap towards the center of the
TorqueMaster
®
spring tube assembly.
Repeat for right hand side.
Shake the TorqueMaster
®
Plus spring tube
assembly gently to extend the winding shafts out
about 5" on each side. For single spring
applications, there will be no left hand spring in
the TorqueMaster
®
Plus spring tube assembly.
Lift the TorqueMaster
®
Plus spring tube assembly
and rest it on the top of the flagangles.
NOTE: Cable drums are marked right and left
hand. Cable drums and TorqueMaster
®
Plus
spring tube assembly are cam shaped to fit
together only one way.
Drum Wraps/ Cable Drums
WINDING SHAFT
5”
TORQUEMASTER
®
SPRING TUBE ASSEMBLY
None
1-1/2 WRAPS
RIGHT DRUM
TORQUEMASTER
®
PLUS
SPRING TUBE ASSEMBLY
(CAM PEAK STRAIGHT UP)
COUNTERBALANCE CABLE
TORQUEMASTER
®
SPRING TUBE
ASSEMBLY
TABS
LEFT HAND DRUM WRAP
LEFT HAND
DRUM WRAP
RIGHT HAND
DRUM WRAP
Tape Measure
Step Ladder