Filter
Top Products
Tools Needed:
16
Please Do Not Return This Product To The Store. Contact your local Wayne-Dalton dealer. To find your local Wayne-Dalton dealer, refer to your
local yellow pages/business listings or go to the Find a Dealer section online at www.wayne-dalton.com
14
Power Drill
7/16” Socket
Driver
7/16” Wrench
IMPORTANT! WHEN CONNECTING A
TROLLEY TYPE GARAGE DOOR OPENER
TO THIS DOOR, A WAYNE-DALTON
OPENER/TROLLEY BRACKET MUST BE
SECURELY ATTACHED TO THE TOP SEC-
TION OF THE DOOR, ALONG WITH ANY
U-BARS PROVIDED WITH THE DOOR. THE
INSTALLATION OF THE OPENER MUST
BE ACCORDING TO MANUFACTURER’S
INSTRUCTIONS AND FORCE SETTINGS
MUST BE ADJUSTED PROPERLY.
Place the top half of the operator
bracket inside the bottom half and hold
flush against the inside of the top sec-
tion (as shown). Adjust the top / bottom
halves out against the U-bar and bottom
rib; loosely secure both halves together
with (4) 1/4” - 20 x 5/8” carriage bolts
and nuts.
NOTE: Install the track bolts as far apart
as possible (as shown), when fastening
the top / bottom halves together.
NOTE: For retro fit applications, the
adjustable operator bracket must be
aligned with the existing operator.
Locate the center of the top section and
align the center of both end tabs of the
adjustable operator bracket with the
sections center line; align the adjustable
operator bracket vertically.
To attach the adjustable operator
bracket:
Attach the operator bracket to the U-bar
with (2) 1/4” - 20 x 11/16” self drilling
screws and the bottom rib with
(2) 1/4” -14 x 5/8” self tapping screws
(as shown).
Now tighten all (4) previously installed
carriage bolts and nuts.
Adjustable Operator
Bracket Installation
ALIGN CENTER OF BOTH
END TABS WITH CENTER
LINE OF TOP SECTION
CENTER LINE OF TOP
SECTION
ADJUSTABLE OPERATOR
BRACKET
(TOP HALF)
ADJUSTABLE OPERATOR
BRACKET
(BOTTOM HALF)
TOP SECTION
BOTTOM RIB
U-BAR
TIGHTEN ALL (4)
CARRIAGE BOLTS
AND NUTS
(2) 1/4” -14 X 5/8”
SELF TAPPING
SCREWS
(4) 1/4” -20 X 5/8”
CARRIAGE BOLTS
AND NUTS
TYPICAL OPERATOR
ARM ATTACHMENT
BOTTOM RIB
U-BAR
(2) 1/4” -20 X 11/16”
SELF DRILLING SCREWS