Filter
Top Products
13
Tools Needed:
Tools Needed:
Please Do Not Return This Product To The Store. Contact your local Wayne-Dalton dealer. To find your local Wayne-Dalton dealer, refer to your
local yellow pages/business listings or go to the Find a Dealer section online at www.wayne-dalton.com
Drums
Warning
Warning
Power Drill
7/16” Socket
Driver
TORQUEMASTER
®
DRUM
BOTTOM SECTION
MILFORD PIN
ROLLERS
ROLLER SLIDE
BOTTOM BRACKET
BOTTOM
SECTION
ASTRAGAL
Roller Slides
Starting with the bottom section, place
a roller slide on the top left side of the
U-Bar and align with the first set of
holes (closest to the section) as shown.
Attach the roller slide to the U-Bar with
(2) 1/4”-14 x 5/8” self tapping screws.
Repeat for opposite side. Install roller
slides on the right and left side of each
U-bar, on all remaining sections with
the exception of the top section.
A viewing hole on the roller slide will
allow for correct positioning of roller
slide on U-bars. Place roller slides on
the sections as follows:
Lock Section (second section) use the
second set of holes.
Intermediate Section (Third section) use
the third set of holes.
Fasten all roller slides to the U-bar with
(2) 1/4”-14 x 5/8” self tapping screws.
None
ROLLER SLIDE
1/4”-14 X 5/8” SELF
TAPPING SCREWS
1
2
3
4
U-BAR
8
9
1
2
3
4
VIEWING HOLE
WARNING LABEL
WARNING LABEL
IMPORTANT: RIGHT AND LEFT HAND IS
ALWAYS DETERMINED FROM INSIDE THE
BUILDING LOOKING OUT.
NOTE: For door section identification see
page 4.
TorqueMaster
®
counterbalance drums
are marked right and left hand. Uncoil
the counterbalance cables and make
sure you place the right hand cable loop
on the right hand milford pin and place
the left hand cable loop on the left hand
milford pin. Insert a roller into bottom
bracket of the bottom section and insert
another roller in the roller slide at the top
of the bottom section. Repeat for other
side.
NOTE: Verify astragal (bottom seal)
is aligned with door section. If there
is more than 1/2” excess astragal on
either side, trim astragal even with door
section.
INSTALLATION