Wayne-Dalton 46 Door User Manual


 
6
Please Do Not Return This Product To The Store. Contact your local Wayne-Dalton dealer. To find your local Wayne-Dalton dealer, refer to your
local yellow pages/business listings or go to the Find a Dealer section online at www.wayne-dalton.com
Tools Needed:
FAILURE TO USE APPROVED
WINDING BARS CAN CAUSE SPRING
ENERGY TO BE RELEASED
SUDDENLY, RESULTING IN SEVERE
OR FATAL INJURY.
COUNTERBALANCE SPRING TENSION
MUST BE RELIEVED BEFORE
REMOVING ANY HARDWARE. A
POWERFUL SPRING RELEASING IT’S
ENERGY SUDDENLY CAN CAUSE
SEVERE OR FATAL INJURY.
Do not release the torsion spring tension
unless you are a qualified and experienced
door technician. Instead have a professional
door agency release the tension.
Step 1: Close the door and place vice
clamps on the back legs of both vertical
tracks, above the third roller to prevent the
door from lifting as you unwind the springs.
Use only approved winding bars available
from your dealer. Do not use undersized
steel rods, screw drivers or anything else
to unwind the springs. Position the ladder
just off to the side of the winding cone.
The winding cone should be easy to reach
without putting your body directly in front
of it.
Step 2: Insert a winding bar into one of the
holes in the winding cone. Exert upward
pressure. Using caution, loosen the two
(2) set screws in the winding cone. Be
prepared to support the full torsional force
of the spring when the set screws are
loosened.
Step 3: Once set screws are loose, slowly
and carefully lower the winding rod until it
rests against the door. Insert other winding
bar into the upper hole. Push up and
remove lower bar. Carefully lower upper
winding bar, 1/4 turns at a time until it rests
against the door. Repeat process until all
tension is relieved. If your door is equipped
with two (2) torsion springs, follow the same
procedure to relieve tension on the second
spring.
Step 4: Remove vice clamps from tracks,
unbolt torsion shaft assembly and remove
from work area.
NOTE: Continue with “P4” on page 9 after
completing this step.
Torsion Spring Removal
For Standard Lift
APPROVED WINDING BAR
TORSION SPRING ASSEMBLY
WINDING CONE
SET SCREWS
FIRMLY HOLD WINDING BARS AND
CAUTIOUSLY LOOSEN SET SCREWS
WARNING
WARNING
P1
Recommended
tools from
page 5