Filter
Top Products
19
Please Do Not Return This Product To The Store. Contact your local Wayne-Dalton dealer. To find your local Wayne-Dalton dealer, refer to your
local yellow pages/business listings or go to the Find a Dealer section online at www.wayne-dalton.com
Tools Needed:
Tools Needed:
INSTALLATION
13
14
Top Section
When installing a door with a
TorqueMaster
®
counterbalance system,
vertical track alignment is critical.
Position flagangle between 1-11/16”
(43 mm) to 1-3/4” (44 mm) from the
edge of the door. Tighten the bottom lag
screw. Flagangles must be parallel to the
door sections. Repeat for opposite side.
IMPORTANT: THE DIMENSION BETWEEN
THE FLAGANGLES MUST BE DOOR
WIDTH PLUS 3-3/8” (86MM) TO 3-1/2”
(89 MM) FOR SMOOTH, SAFE DOOR
OPERATION.
Complete the vertical track installation
by securing the center jamb bracket(s)
and tightening the other lag screws.
Push the vertical track against the rollers
so that the rollers are touching the
deepest part of the curved side of the
track (see illustration). Tighten all the
track bolts and nuts. Repeat for opposite
side.
Vertical Track
DOOR WIDTH
+3-3/8” TO 3-1/2”
NAIL
1-11/16” TO 1-3/4”
FLAGANGLE
TOP SECTION
Place the top section in the opening and
vertically align with lower sections.
Temporarily secure the top section by
driving a nail in the header near the
center of the door and bending it over
the top section.
Now flip up the hinge leaf against
section, fastening center hinges first and
end hinges last.
Power Drill
7/16 Socket
Driver
Tape Measure
Hammer
Nail
Power Drill
7/16 Socket
Driver
ROLLER
VERTICAL TRACK
ROLLER AGAINST
VERTICAL TRACK