Wayne-Dalton 46 Door User Manual


 
14
Please Do Not Return This Product To The Store. Contact your local Wayne-Dalton dealer. To find your local Wayne-Dalton dealer, refer to your
local yellow pages/business listings or go to the Find a Dealer section online at www.wayne-dalton.com
Tools Needed:
Locate the lower (numbered) leaf of
the #1 end hinges and required center
hinges over the #1 and #4 holes in the
end stiles for the end hinges and the
pre-punched holes in the center stile(s)
for the center hinges at the top of the
section.
NOTE: The #1 hinges serve as end
hinges on the bottom section. The #1
hinges also serve as center hinges at all
center hinge locations.
Secure the hinges to the section using
(2) 1/4”-14 x 5/8” self tapping screws
on each hinge leaf.
Insert roller into appropriate hinge tube.
Repeat for all other sections using the
#2 end hinges on the second (lock
section) and the #3 end hinges on the
third section (intermediate section).
NOTE: #4 End hinges are used on fourth
section of five section doors.
IMPORTANT: WHEN PLACING ROLLERS
INTO END HINGES NUMBER 2 AND
HIGHER, THE ROLLER GOES INTO THE
TUBE FURTHEST AWAY FROM SECTION.
IMPORTANT: ONCE FASTENER IS
SNUG AGAINST HINGE LEAF, TIGHTEN
AN ADDITIONAL 1/4 TO 1/2 TURN TO
RECEIVE MAXIMUM DESIGN HOLDING
POWER.
Hinges
END STILE HOLE
PATTERN
(LEFT SIDE IS SHOWN.
RIGHT SIDE IS
OPPOSITE.)
7
6
5
4
3
2
1
#1 HINGE #2 END HINGE
#3 END HINGE #4 END HINGE
CENTER STILE
HOLE PATTERN
ROLLER
PLACEMENT
ROLLER
PLACEMENT
ROLLER
PLACEMENT
HINGE
(2) 1/4”-14 X 5/8”
SELF TAPPING
SCREWS
CENTER STILE
(2) 1/4”-14 X 5/8”
SELF TAPPING
SCREWS
HINGE
END STILE
END HINGE PLACEMENT
CENTER HINGE PLACEMENT
#4 HOLE
#1 HOLE
Power Drill
7/16” Socket
Driver
5