Filter
Top Products
Tools Needed:
6
Please Do Not Return This Product To The Store. Contact your local Wayne-Dalton dealer. To find your local Wayne-Dalton dealer, refer to your local
yellow pages business listings or go to the Find a Dealer section online at www.Wayne-Dalton.com
FAILURE TO USE APPROVED
WINDING BARS CAN CAUSE
SPRING ENERGY TO BE RELEASED
SUDDENLY, RESULTING IN SEVERE
OR FATAL INJURY.
COUNTERBALANCE SPRING
TENSION MUST BE RELIEVED
BEFORE REMOVING ANY
HARDWARE. A POWERFUL
SPRING RELEASING IT’S ENERGY
SUDDENLY CAN CAUSE SEVERE OR
FATAL INJURY.
Do not release the torsion spring
tension unless you are qualified and
experienced door technician. Instead have
a professional door agency release the
tension.
Step 1: Close the door and place vice
clamps on the back legs of both vertical
tracks, above the third roller to prevent
the door from lifting as you unwind the
springs. Use only approved winding bars
available from your dealer. Do not use
undersized steel rods, screw drivers or
anything else to unwind the springs.
Position the ladder just off to the side
of the winding cone. The winding cone
should be easy to reach without putting
your body directly in front of it.
Step 2: Insert a winding bar into one
of the holes in the winding cone. Exert
upward pressure. Using caution, loosen
the two (2) set screws in the winding
cone. Be prepared to support the full
torsional force of the spring when the set
screws are loosened.
Step 3: Once set screws are loose, slowly
and carefully lower the winding rod until it
contacts the door. Insert other winding bar
into the upper hole. Push up and remove
lower bar. Carefully lower upper winding
bar, 1/4 turns at a time until it contacts
the door. Repeat process until all tension
is relieved. If your door is equipped with
two (2) torsion springs, follow the same
procedure to relieve tension on the second
spring.
Step 4: Remove vice clamps from tracks,
unbolt torsion shaft assembly and remove
from work area.
NOTE: Continue with “P4” on page 9 after
completing this step.
WARNING
WARNING
P1
Approved
Winding Bars
3/8” Wrench
Vice Clamp
Recommended
tools from
page 5
Torsion Spring Removal
For Standard Lift
APPROVED WINDING BARS
WINDING CONE
TORSION ASSEMBLY
SET SCREWS
FIRMLY HOLD WINDING
BAR AND CAUTIOUSLY
LOOSEN SET SCREWS
WINDING CONE