Filter
Top Products
21
Tools Needed:
Tools Needed:
Please Do Not Return This Product To The Store. Contact your local Wayne-Dalton dealer. To find your local Wayne-Dalton dealer, refer to your local
yellow pages business listings or go to the Find a Dealer section online at www.Wayne-Dalton.com
TorqueMaster
®
Spring Tube
TorqueMaster
®
springs come lubricated
and pre-assembled inside the
TorqueMaster
®
spring tube. To install, lay
the TorqueMaster
®
spring tube on the
floor (inside garage) in front of the door
with the labeled end to the left.
LABELED END
TORQUEMASTER
®
SPRING TUBE
None
17
Center Bracket Bushing
NOTE: If you are installing the idrive
®
opener with your garage door, skip this
step and go to your idrive
®
Installation
Instruction/Owner’s Manual. After
completing Steps 1 thru 10 in your
idrive
®
Installation Instruction/Owner’s
Manual, continue with Step 22 of the
door Installation Instruction/Owner’s
Manual.
NOTE: If you are not installing an idrive
®
opener with your garage door, you
must install the center bracket bushing
assembly. Continue to follow these
instructions for non-idrive
®
operated
garage doors.
Being cam shaped the center bracket
bushing only fits one way.
Slide the center bracket assembly
towards the center of the TorqueMaster
®
spring tube, from the right side as
shown.
CENTER
BRACKET
ASSEMBLY
TORQUEMASTER
®
SPRING TUBE
TORQUEMASTER
®
SPRING TUBE
CENTER
BRACKET
BUSHING
None
INSTALLATIONINSTALLATION