Filter
Top Products
23
Tools Needed:
Tools Needed:
Please Do Not Return This Product To The Store. Contact your local Wayne-Dalton dealer. To find your local Wayne-Dalton dealer, refer to your local
yellow pages business listings or go to the Find a Dealer section online at www.Wayne-Dalton.com
INSTALLATIONINSTALLATION
The winding shaft must extend past the
cable drum far enough to expose the
splines and the groove. Align the winding
shaft groove with the round notch in the
flagangle.
For double spring applications:
Repeat for opposite side.
For single spring applications: Insert
the loose winding shaft into the left
hand cable drum prior to sliding the
cable drum over the TorqueMaster
®
spring tube assembly.
NOTE: On single spring applications,
take care in handling the loose winding
shaft (left side) so that it does not slide
back into the TorqueMaster
®
spring tube
assembly.
WINDING SHAFT
CABLE
DRUM
GROOVE
ROUND NOTCH
FLAGANGLE
SPLINES
COUNTERBALANCE CABLE
Cable Drums Continued...
LOOSE WINDING SHAFT
GROOVE
CABLE
DRUM
SPLINES
WINDING SHAFT
Cable Drum
No space between Ratchet
Pawl and Cable Drum
indicates engagem
ent
Cable Drum
Ratch
et Pawl
ENGAGED SIDE VIEW
No space between
Ratchet Pawl and
Cable Drum
ENGAGED UNDERNEATH VIEW
Space between Ratchet Pawl
and Cable Drum
non-indicates engagement
Cable Drum
Ratchet Pawl
DISENGAGED SIDE VIEW
No space between
Ratchet Pawl and
DISENGAGED U
NDERNEATH VIEW
UPPER POSITION
LOWER POSITION
LOWER POSITION SIDE VIEW
UPPER POSITION SIDE VIEW
Ratchet Pawl in Lower Position
Ratchet Pawl in Upper Position
Use these Illustr
ation, in conjunction with the Instructions on the other side of
this label.
WARNING
Rachet Bracket
is under
EXTREME
SPRING
TENSION
.
To avoid po
ssible severe or
fatal injury
,
DO
NOT
remove
fasteners from ratchet
bracket
until spring(s
) are fully
wnwou
nd.
To safely unwind spring(s)
read
and fol
low the directions i
n the
installation ins
tructions/owne
rs
manual
.
DO NOT REMOVE T
HIS TAG.
IMPORTANT: WARNING TAGS MUST BE
SECURELY ATTACHED TO BOTH END
BRACKETS.
End brackets are right and left hand. You
can identify the right hand end bracket
by the disconnect cable guide hole in
the top of the bracket.
Beginning with either side, slide the end
bracket onto the winding shaft so that
the grooves in the ratchet wheel fit onto
the winding shaft splines.
SPLINES
WINDING
SHAFT
GROOVE
DISCONNECT
CABLE GUIDE
HOLE
RIGHT END
BRACKET
WARNING
TAG
20
End Brackets
Power Drill
7/16” Socket
Driver
9/16” Wrench