Filter
Top Products
Tools Needed:
31
Please Do Not Return This Product To The Store. Contact your local Wayne-Dalton dealer. To find your local Wayne-Dalton dealer, refer to your local
yellow pages business listings or go to the Find a Dealer section online at www.Wayne-Dalton.com
INSTALLATION
If the system is engaged, follow these
steps to reset the system:
2. Disengage opener (if installed) by
pulling or placing emergency disconnect
in the manual operated position.
3. With the door in the open position,
clamp vice grips on both tracks just below
the bottom section roller.
4. Now is a good time to remove vehicles
from garage, and provide clear access to
end brackets.
5. Flip the ratchet pawl knob on both
end brackets to the upper position (see
illustration).
6. Raise door 2”-3” and then lower door.
Repeat process until anti-drop device
resets (see disengaged illustrations on
reverse side).
IMPORTANT: BE PREPARED TO SUPPORT
THE TOTAL WEIGHT OF THE DOOR.
7. Cautiously remove the vice clamps from
both tracks and with assistance lower the
door.
8. Check for spring tension. Starting on
the right hand side, place a ratchet and
5/8” socket on the Torquemaster
®
Plus
winding shaft (see illustration in
instruction manual). Ensure ratchet is set
so that it will tighten counter clockwise on
the right hand side, and clockwise on the
left hand side (if applicable). If tension is
present, remove the ratchet and check the
left hand side (if applicable). If spring(s)
have tension, proceed to Balancing Door
Step 1; if no spring tension is present,
contact a qualified door installation
company to replace the spring(s).
IMPORTANT: HAVE A QUALIFIED DOOR
INSTALLATION COMPANY MAKE
ADJUSTMENTS/REPAIRS TO CABLES,
SPRING ASSEMBLIES AND OTHER
HARDWARE.
BALANCING DOOR
1. Lift door and check its balance. Adjust
spring(s), if door lifts by itself (hard to pull
down) or if door is difficult to lift (easy to
pull down). Anytime spring adjustments
are made, ratchet pawl knob must be
in the upper position (see illustration on
reverse side). An unbalanced door such as
this can cause idrive
®
or Torquemaster
®
Plus operation problems.
PLACE VICE CLAMPS
BELOW BOTTOM SECTION
ON BOTH VERTICAL TRACK
PAWL KNOB IN LOWER
POSITION
PAWL KNOB IN UPPER
POSITION
LOWER POSITION
UPPER POSITION
Cable Drum
No space between Ratchet
Pawl and Cable Drum
indicates engagement
Cable Dr
um
Ratchet Pawl
ENGAGED SIDE VIEW
No space between
Ratchet Pawl and
Cable Drum
ENGAGED UNDERNEATH VIEW
Space between Ratchet Pawl
and Cable Drum
non-indicates engagement
Cable Drum
Ratchet Pawl
DISENGAGED SIDE VIEW
No space between
Ratchet Paw
l and
DISENGAGED U
NDERNEAT
H VIEW
UPPER POSITION
LOWER POSITION
LOWER POSITION SIDE VIEW
UPPER POSITION SIDE VIEW
Ratchet Pawl in Lo
wer Position
Ratchet Pawl in Upper Position
Use these Illustration, in conjunction with the Instructions on the other side of
this label.
WARNING
Rachet Bracket is under
EXTREME SPRING
TENSION
.
To avoid possible severe or
fatal injury,
DO NOT
remove
fasteners from ratchet bracket
until spring(s) are fully
wnwound.
To safely unwind spr
ing(s)
read
and follow the direc
tions in the
installation instructions/owners
manual.
DO NOT REMOVE THIS TAG.
RATCHET
WITH 5/8”
SOCKET
END BRACKET
3” EXTENSION
TorqueMaster
®
Plus Reset
Instructions Continued...
PAWL