Filter
Top Products
Tools Needed:
18
Please Do Not Return This Product To The Store. Contact your local Wayne-Dalton dealer. To find your local Wayne-Dalton dealer, refer to your local
yellow pages business listings or go to the Find a Dealer section online at www.Wayne-Dalton.com
FULLY ADJUSTABLE
ROLLER
VERTICAL TRACK
ROLLER AGAINST
VERTICAL TRACK
1-11/16” TO 1-3/4”
FLAGANGLE
TOP
SECTION
Top Section
Place the top section in the opening and
vertically align with lower sections. Align
vertical marks in the upper alignment
sticker, with the lower alignment sticker
on right hand side on the back of door.
Temporarily secure the top section by
driving a nail in the header near the
center of the door and bending it over
the top section.
Now, flip up hinge leafs, hold them tight
against section and fasten center hinges
first and end hinges last. (Refer to Step
9).
When installing a door with a
TorqueMaster
®
counterbalance system,
vertical track alignment is critical.
Position flagangle between 1-11/16”
(43 mm) to 1-3/4” (44 mm) from the
edge of the door. Flagangles must be
parallel to the door sections. Now,
complete the vertical track installation
by securing the center jamb bracket and
tightening the other lag screws.
Repeat for other side.
IMPORTANT: THE DIMENSION BETWEEN
THE FLAGANGLES MUST BE DOOR-
WIDTH PLUS 3-3/8” (86 MM) TO 3-1/2”
(89 MM) FOR SMOOTH, SAFE DOOR
OPERATION.
For quick install track:
Complete the vertical track installation
by securing the center jamb bracket(s)
and tightening the other lag screws.
Repeat for opposite side.
For fully adjustable track:
Complete the vertical track installation
by securing the center jamb bracket(s)
and tightening the other lag screws.
Push the vertical track against the
rollers so that the rollers are touching
the deepest part of the curved side of
the track (see illustration); tighten all the
track bolts and nuts. Repeat for opposite
side.
12
Hammer
DOOR WIDTH
+3-3/8” TO 3-1/2”
NAIL
327985 NEW 9-04-06
327985 NEW 9-04-06
RIGHT END HINGE SIDE
ALIGNMENT STICKERS