Filter
Top Products
Chapter 5 Installing the Tracer MP581 programmable controller
58 BAS-APG001-EN
Mounting the back of the enclosure
The back of the enclosure is shipped with the termination board installed
inside it.
IMPORTANT
The termination board should be shipped with the grounding screw
installed. Verify this by checking the location shown in
Figure 28.
The enclosure door is shipped separately. If the door has already been
attached to the enclosure back, remove it.
To mount the enclosure:
1. Using the enclosure as a template, mark the location of the four
mounting holes on the mounting surface (see
Figure 28).
Figure 28. Enclosure mounting holes
Mounting hole
(four locations)
Termination board
grounding screw
(must be installed)