Filter
Top Products
Remote Operation Model GFC7001E Carbon Dioxide Analyzer
Teledyne Analytical Instruments 161
Note: If you are adding an instrument to the end of a previously configured chain, remove the shunt
between Pins 21 22 of JP2 on the multidrop PCA in the instrument that was previously the last
instrument in the chain.
3. Close the instrument.
4. Using straight-through, DB9 male DB9 Female cable, interconnect the host and the analyzers as
shown in Figure 8-4.
5. BEFORE communicating from the host, power on the instruments and check that the Machine ID code is
unique for each. (On the front panel menu, use SETUP>MORE>COMM>ID. Note that the default ID is
typically the model number; to change the 4-digit identification number, press the key below the
corresponding digit to be changed).
NOTE
Teledyne recommends setting up the first link, between the Host and the first instrument and testing it
before setting up the rest of the chain.
CALIBRATOR
CALIBRATOR
TAPI Analyzer
Last
INSTRUMENT
Female DB9
Male DB9
RS-232
COM2
RS-232
COM2
RS-232
COM2
RS-232
COM2
Host
RS-232 port
Make Sure
Jumper between
JP2 pins 21
22
is installed.
KEY:
Figure 8-4: RS-232-Multidrop PCA Host
/Analyzer Interconnect Diagram