Filter
Top Products
5
Model C006 To the Installer
Air Clearance
Always allow a minimum of 1” (25.4 mm) at the rear and 4” (102 mm) under the unit for
adequate air flow.
Warranty
One year parts and labor, excluding wear items.
CAUTION: Warranty is valid only if required service work is provided by an Authorized
Taylor Service Technician.
Note: Warranty is valid only if the parts are authorized Ta ylor parts, purchased from an
authorized Taylor Distributor, and the required service work is provided by an authorized
Taylor service technician. Taylor reserves the right to deny warranty claims on equipment
or parts if non-approved parts were installed in the machine, system modifications were
performed beyond factory recommendations, or it is determined that the failure was
caused by neglect or abuse.
IMPORTANT: The unit must be cleaned, primed and calibrated prior to the first use.
ALL flavors and the sugar must be calibrated at time of start up. It is NOT optional
to calibrate only one or two flavors. If these procedures are not followed completely, the
CUSTOM (combination) selector button will not operate.