Filter
Top Products
21
Model C006 Operating Procedures
Product Tube Removal/Installation
Step Action
1 Discard any remaining product in the tank.
2 Wash and rinse the tank and the lid.
3 Fill the tank with clean water to the fill line on the tank.
4 Place a cup under the dispensing spout.
Note: Refer to the “Clean Flavors and Liquid Sugar”
instructions within the Service Menu on page 14.)
5 Activate the flavor selection corresponding to the product
tube in need of replacement. This will pump the water from
the tank and tube.
6 Remove the product tank.
7 Place the dispenser power switch in the OFF position.
8 Unplug the dispenser from the wall receptacle.
9 Remove the right side panel.
10 Carefully open the pump cover.
11 Remove the product tube from the stainless tubes.
12 Install the new product tube onto the stainless steel tubes.
13 Route the product tube through the pump. (Besureto
route the tube properly. The pumps are directional.)
14 Carefully align the product tube, making sure the tube is
centered over the pump rollers.
15 Press down on the tube at both ends to remove slack and
carefully close the pump cover. Make sure there are no
kinks and that the tu b e stays centered over the rollers.