Filter
Top Products
6
To the Installer Model C006
Installing the Flavor Shot Dispenser
Step Action
1 Place the flavor shot dispenser where it will best serve
your operation.
2 Make sure that counters, platforms, and shelves are strong
enough to support the weight of the dispenser and full
containers of product (109 lbs. [49 kg.]).
3 Maintain a minimum of 1” (25.4 mm) at the rear and 4”
(102 mm) under the unit for adequate air flow.
4 DO NOT remove the legs from the dispenser or allow
the dispenser to sit directly on the counter.
Adequate air flow under the m achine is necessary for
proper operation.
Make sure the legs at the four corners of the dispenser are
firmly attached.
Removal of the legs violates the warranty.
5 Make sure the unit is level.
6 Plug the power cord into the proper electrical outlet (NEMA
5-15P).
7 Install the drip tray and the splash shield.