Sharp R-2397 Air Conditioner User Manual


 
R-2397
19
Pin No. Signal I/O Description
27 RESET IN Auto clear terminal.
Signal is input to reset the LSI to the initial state when power is supplied. Temporarily set
to "L" level the moment power is supplied, at this time the LSI is reset. Thereafter set at
"H" level.
28 XIN IN
Internal clock oscillation frequency setting input.
The internal clock frequency is set by inserting the ceramic filter oscillation circuit with
respect to XOUT terminal.
29 XOUT OUT
Internal clock oscillation frequency control output.
Output to control oscillation input of XIN.
30/31 XCIN/XCOUTIN/OUT Terminal not used.
32 VSS IN
Power source voltage: -5V.
VC voltage of power source circuit input.
33 ø OUT Terminal not used.
34 R3 IN
Signal coming from touch key.
When either one of G-12 line keys on key matrix is touched, a corresponding signal out
of P11, P12, P14-P17 will be input into R3. When no key is touched, the signal is held at
"L" level.
35 R2 IN
Signal similar to R3.
When either one of G-11 line keys on key matrix is touched, a corresponding signal will
be input into R2.
36 R1 IN
Signal similar to R3.
When either one of G-10 line keys on key matrix is touched, a corresponding signal will
be input into R1.
37 R0 IN
Signal similar to R3.
When either one of G-9 line keys on key matrix is touched, a corresponding signal will
be input into R0.
38 VP IN
Anode (segment) of Fluorescent Display light-up voltage: -31V
Vp voltage of power source circuit input.
39 P17 OUT
Segment data signal.
The relation between signals and indicators are as follows:
Signal Segment Signal Segment
P24 .................. i P13 ..................... f
P23 ................j,k P12 .................... e
P17 ............... LB P11 .................... d
P16 .............. UB P10 .................... c
P15 ................. h P07 .................... b
P14 ................. g P06 .................... a
Key strobe signal.
Signal applied to touch-key section. A pulse signal is input to R0-R3 terminal while one
of G-6 line keys on key matrix is touched.
40 P16 OUT
Segment data signal. Signal similar to P17.
Key strobe signal.
Signal applied to touch-key section. A pulse signal is input to R0-R3 terminal while one
of G-5 line keys on key matrix is touched.
41 P15 OUT
Segment data signal. Signal similar to P17.
Key strobe signal.
Signal applied to touch-key section. A pulse signal is input to R0-R3 terminal while one
of G-4 line keys on key matrix is touched.
42-43 P14-P13 OUT
Segment data signal.
Signal similar to P17.
44 P12 OUT
Segment data signal. Signal similar to P17.
Key strobe signal.
Signal applied to touch-key section. A pulse signal is input to R0-R3 terminal while one
of G-8 line keys on key matrix is touched.
45 P11 OUT
Segment data signal. Signal similar to P17.
Key strobe signal.
Signal applied to touch-key section. A pulse signal is input to R0-R3 terminal while one
of G-7 line keys on key matrix is touched.
GND
-31(V)
ß(50Hz)