Filter
Top Products
SMC sierra monitor corporation Sentry Instruction Manual - Version 6
CONFIGURATION PROCEDURE
Page: 41
SENTRY KEY BOARD
Ts = TEST R = RESET M = MODE T = TIME ^ = ARROWS E = ENTER
RESET KEY * GLOBAL CALIBRATION
Reset Alarms R E Gas Type (Concentration) ^ E
Reset System R R E Enter to Span E
Reset History R R R E Apply Zero Gas E
TIME KEY Enter to Span E
Check History T E Apply Span Gas E
Printer History T T E Operate Mode (After timer) E
Print System T T T E * LOCAL CALIBRATION
Print Status T T T T E Gas Type (Concentration) ^ E
Set Date & Time T T T T T E Apply Zero & Span E
TEST KEY Operate Mode (After timer) E
Test System Ts E * CHANGE MODULE
Test Alarms Ts Ts E Module # ^ E
MODE KEY - PASSIVE Gas Type ^ E
Change/Calib M E Module On/Off ^ E
Select Scan M M E Low Alarm Latch/Non ^ E
Check Calib M M M E High Alarm Latch/Non ^ E
Check Module M M M M E High Alarm Value ^ E ^ E ^ E
MODE KEY - ACTIVE Low Alarm Value ^ E ^ E ^ E
Change/Calib M E Scaling Factors ^ E ^ E ^ E
Calibrate * E * SET USER CODE
Change Calibrate * M E User Number ^ E
Change Module * M M E Entry Code ^E ^E ^E ^E
Set User Code * M M M E * CHANGE PRINTER
Change Printer * M M M M E Printer On/Off ^ E
Change Gas Tag M M M M M E Controller ID ^^ E
Change Module Tag M M M M M M E Status Frequency ^^ E
* CHANGE CALIB Print History ^ E
Gas Type ^^ E Gas Type ^^ E
Full Scale ^^ E ^^ E ^^ E Min. Conc. ^^ E
Calib Concentration ^^ E ^^ E ^^ E Conc. Change ^^ E
Calib Frequency ^^ E Gas Type ^ E
Global Calib ^ E Exit R
Figure 4-2
Sentry Keyboard - Quick Help