Filter
Top Products
DV425TR DIRECT VENT ROOM HEATER
02/01 Page 15 250-5533
The logset is packed in the components box and consists of the
following: (See Fig. 1)
Qty. # in Fig. 1
1 Rear log - 1
1 Left Partial Log - 2
1 Right Partial Log - 3
1 Left Twig - 4
1 Right Twig - 5
While breakable, the logs do not become fragile until after the
stove is burned and they have cured. After curing, any handling
must be done with care as breakage may occur easily.
Please Note: Logs have been designed to work specifically
with the burner pan of the 425TR. Exact placement will
ensure maximum operation of your heater.
Installation:
1. Set the Rear Log over the pins at the rear of burner pan.
(See white circles in Fig. 2)
2. Set Left and Right Partial Logs (with butt end towards side
of stove firebox), over the left and right side pins on burner
pan. Fig. 3
3. Locate the pin hole on the bottom of the right and left twigs
and situate them over the white pins located on Rear Log.
Fig. 4
IMPORTANT!
Lava rock must only be placed in the recessed area to
the front and sides of burner pan.
4. Place nuggets sparingly across front of burner. Note the
white nuggets in Fig. 5
5. Tear off varying sizes of mineral wool and intersperse among
the nuggets.
6. Carefully deposit a layer of lava rock in the channel area
along both sides and in front. Fig. 6
1
2
3
4 5
Fig. 1
Fig. 3
Fig. 2
LOGSET INSTALLATION
Fig. 5
Fig. 4
Fig. 6
Channel area
to keep lava
rock in is
shaped like
this outline.