Filter
Top Products
DV425TR DIRECT VENT ROOM HEATER
02/01 Page 14 250-5533
LP CONVERSION, CONT.
Valve Regulator Replacement
1. Turn control knob to the OFF position, ensure that gas
supply to the valve has been turned off.
2. Using a Torx TH20, or slotted screwdriver, remove the
three pressure regulator mounting screws (A), pressure
regulator tower (B), and diaphragm (C). (You may wish
to retain these items for converting back to original gas
if necessary.)
3. Ensure that the rubber gasket (D) is properly positioned
and install the new HI/LO pressure regulator assembly
to the valve using the new screws (E) supplied with
the kit. Tighten screws securely. (Reference torque
= 25 in/lb)
4. Install the enclosed identication label (F) to the valve
body where it can be seen.
5. Re-install burner plate: First slide burner tube into shut-
ter and over holes. Secure plate with screws.
6. Re-install log/burner pan. Slide vertically into the back
of rebox and then place horizontal onto burner plate.
Refer to Fig. 1 again.
7. Install logs, refer to Owner's Manual for correct place-
ment.
8. Replace glass door and front.
A
B
C
E
D
F