Filter
Top Products
34
The red light on the hand-
held remote control stays
on during installation.
Press the button located beneath the label with a
pencil and then press
ARM. If it still stays on, re-
move the battery, wait a few seconds, then replace
the battery. Press the button and then
ARM again.
The red light on the sensor/
motion detector stays on
during installation.
Press
CODE, then press TEST on the sensor/mo-
tion detector. If it still stays on, remove the battery,
wait a few seconds, and then replace the battery.
Press
CODE, then press TEST again.
ARMED
flashes. This indicates that there has been an intrusion. Al-
so, if a zone indicator is on, this indicates which
zone was violated. To turn the zone indicator off
and stop the armed indicator from flashing, press
the
LIGHT ON or OFF button on a remote control. If
a zone indicator is not on, the violated zone is with-
in zones 9-16. Press
BYPASS on the console to see
which zone was tripped.
A motion detector causes
“false alarms.”
Motion detectors sense motion by detecting a
change in temperature; therefore, do not place the
motion detector near an air conditioning or heating
vent.
Do not place it in a direct source of bright light, such
as sunlight.
It could be detecting a pet’s movements. Place the
detector at a height of 6 feet, or set the switch on
the back to 2 so it is less sensitive.
The console does not dial
out.
Check that you have stored a phone number (see
“Setting up Phone Numbers” on page 22).
Check that the console is armed
The console does not play
back any message when
the phone is answered.
Check that you have recorded a message (see
“Recording a Voice Message” on page 24).
Problem Solution
49-2551AB.fm Page 34 Friday, February 19, 1999 3:41 PM