Filter
Top Products
28
Reading the Status of
Zones 1–8
•
Steady On
— door or window is
open.
•
Steady Off
— door or window is
closed.
•
Slow Flashing
— wireless sensor
transmitter is reporting a problem
(such as a low battery).
•
Fast Flashing
— wireless sensor
transmitter reported a problem
(such as an open window or a low
battery) and you pressed
BYPASS
on the console (see “Trouble
Alarm”).
Trouble Alarm
If you hear a repetitive trouble alarm
when you try to arm the system, this in-
dicates that there is a problem.
The system does not arm until you:
•
Correct the Problem
— Press
DISARM to stop the trouble alarm.
Check the zone reporting the
problem to see if a door or window
is open or a sensor’s battery is
dead. Then arm the system again.
•
Ignore the Problem
— Press
BYPASS on the console while the
trouble alarm is sounding.
The indicator(s) for the problem
zone(s) flash rapidly. Press
ARM
HOME/ARM AWAY
to arm the sys-
tem. The problem zone(s) are not
protected, but all other zones arm
Note:
If you bypass an open window or
door and arm the system, then later
close the window or door, that zone
then arms.
Reading the Status of
Zones 9–16
If there is a problem with zones 9–16,
the console does not show a flashing
zone light, but you hear the trouble
alarm if you try to arm the system.
Hold down
BYPASS on the console.
The indicator lights show which zone
(9–16) is reporting the problem. If you
do not want to bypass the problem,
correct it and arm the system again.
49-2551AB.fm Page 28 Friday, February 19, 1999 3:41 PM