Filter
Top Products
32
The alarm trips when you
enter the house before you
have time to disarm it.
Arm the system in the delay mode. Set the
DELAY
switch on the entry door sensor to MAX. Set the EN-
TRY
switch on the handheld remote control to DE-
LAY
, and then press ARM HOME or ARM AWAY on
the handheld remote control.
You cannot turn lights on or
off using the
LIGHT ON or
LIGHT OFF buttons on the
remote.
Make sure you set the house and unit code on the
module(s) to the same letter and number as the
console.
If you have more than one console, ensure that you
set both to the same house and unit code.
Be sure the light you are trying to control is plugged
in and has its on/off switch in the on position, and
that its bulb is good.
Plug the module into another outlet on the same
electrical circuit as the console.
Check that the battery indicator on the remote con-
trol comes on when you press a button. Replace
the battery and re-initialize the remote control, if
necessary.
You open a door or window
and the alarm does not trip.
Check to see if the system is armed.
Be sure
INSTALL/RUN 1/RUN 2 on the console is set
to
RUN1 or RUN 2.
Press
TEST on the wireless sensor transmitter and
see if the alarm trips. If the alarm does not trip, see
if the sensor indicator comes on when you press
TEST. If the indicator does not come on, replace the
battery and re-initialize the sensor, if necessary.
Problem Solution
49-2551AB.fm Page 32 Friday, February 19, 1999 3:41 PM