Filter
Top Products
12
2. Press ARM on the remote control.
The indicator on the remote con-
trol blinks.
3. Set the console’s
INSTALL/RUN 1/
RUN 2
switch to INSTALL.
4. Stand near the console and press
ARM again. The indicator blinks
again, and the console chimes
and logs in the remote control.
5. Leave the console’s switch set to
INSTALL to install other accesso-
ries.
Notes:
• You can add any combination of
up to eight Plug ’n Power
remote controls.
• When you press a button,
BAT-
TERY
lights on the remote con-
trol to show the battery is good.
INSTALLING THE
HANDHELD REMOTE
CONTROL
1. Press the tab on the battery com-
partment cover and lift off the
cover.
2. Install four AAA alkaline batteries
in the handheld remote control’s
battery compartment, according
to the polarity symbols (+ and –)
marked inside the compartment.
3. Be sure the console’s
INSTALL/
RUN 1/RUN 2
switch is set to
INSTALL.
4. Set the house code on the remote
control to the same letter as the
console.
5. Press
ARM HOME or ARM AWAY
on the handheld remote control.
The console chimes.
Still Missing-Paste in
this illustration at
Proof to Mass Print
stage.
49-2551AB.fm Page 12 Friday, February 19, 1999 3:41 PM