Filter
Top Products
16
TESTING THE SYSTEM
After you have completed all of the
quick installation procedures, follow
these steps to test the system.
Note:
To avoid unnecessarily alarming
your neighbors, tell them you are test-
ing the system.
1. Set the
INSTALL/RUN 1/RUN 2
switch on the console to RUN 2.
REC/BUSY
lights for 15 seconds.
2. Place each wireless sensor trans-
mitter’s magnet next to its mag-
netic switch with the arrows
pointing toward each other.
3. Place the motion detector on a
counter top within 100 feet of the
console.
4. Move a wireless sensor transmit-
ter’s magnet away from the mag-
netic switch.
When the system is not armed
and set to
RUN2, the console
emits a chime every time some-
one opens a door or window. The
system does not chime when it is
set to
RUN 1.
Replace the magnet next to the
magnetic switch.
5. Press
ARM on a remote control,
and then move the magnet away
from the magnetic switch again.
The alarm sounds and the lamp
connected to the lamp module
flashes on and off. Press
DISARM
to turn off the alarm, and LIGHTS
OFF
to turn off the lamp. Replace
the magnet next to the magnetic
switch.
6. Press
ARM AWAY on the remote
control, then walk across the path
of the motion detector’s lens. The
alarm sounds and the lamp con-
nected to the lamp module flashes
on and off. Press
DISARM to turn
off the alarm. The console chimes
twice. Press
LIGHTS OFF to turn
off the lamp.
49-2551AB.fm Page 16 Friday, February 19, 1999 3:41 PM