Filter
Top Products
33
You do not hear a chime
from the console when you
press
ARM to install a re-
mote.
Check if you can arm the system when
INSTALL/
RUN 1/RUN 2
on the console is set to RUN 1
or RUN
2
. If you can, the remote control is already installed
and no further action is necessary. If not:
1. Set
INSTALL/RUN 1/RUN 2 on the console to
INSTALL.
2. Press
CODE (located beneath the label on the
remote control) with a pencil, then press
ARM
again.
You do not hear a chime
from the console when you
press
TEST to install a wire-
less sensor transmitter or
motion detector.
With
INSTALL/RUN 1/RUN 2 on the console set to
RUN 2, check that the console chimes when you
press
TEST on the sensor or motion detector. If it
does, the sensor or motion detector is already in-
stalled and no further action is necessary. If not:
1. Set
INSTALL/RUN 1/RUN 2 on the console to
INSTALL.
2. Press
CODE on the sensor or motion detector
with a pencil, then press
TEST again.
Note:
If the sensor/motion detector is already in-
stalled, it is installed again into the next available
zone.
BATTERY LOW on the
console is on.
Install or replace the console’s battery.
You lose your remote con-
trol.
Purchase a replacement remote control (Cat. No.
49-2551T or 49-2591), and then completely re-
install your system using different house and unit
codes to prevent someone else from using the lost
remote control.
The system arms or dis-
arms by itself.
A neighbor may have a compatible system. Re-
install the system using a different house code.
Problem Solution
49-2551AB.fm Page 33 Friday, February 19, 1999 3:41 PM