27
Notes:
• The supplied motion detector
(Cat. No. 49-2589) only operates
in the
INSTANT mode.
If you want to use the exit/entry
delay feature, you can use
another motion detector (Cat. No.
61-2614) instead of the one sup-
plied with this system. However,
the
ARM HOME feature might not
work.
• You must set the switch inside the
wireless sensor transmitter’s bat-
tery compartment to
MAX in order
for it to arm in the delay mode.
When set to
MIN, the sensor
immediately arms, regardless of
whether the handheld remote con-
trol is set to
DELAY or INSTANT.
• The
ARM button on the console
automatically arms the system in
the
DELAY mode.
• The keychain remote control only
arms the system in the
INSTANT
mode.
• Other separately purchased
remote controls might arm the
system only in either the
DELAY or
INSTANT mode. See the remote
control’s owner’s manual.
USING THE PANIC
ALARM
Pressing PA NI C on the handheld re-
mote control, or
ARM and DISARM at
the same time on the keychain remote
control, causes the console’s alarm to
sound, even if the system is not armed.
Note:
The telephone dialer does not
dial out unless the system is armed.
ZONE INDICATORS
All sensors and motion detectors re-
port to the console about every 90 min-
utes. If the console does not receive a
signal from a sensor within 4 hours, it
reports a problem with that sensor by
slowly flashing its zone indicator.
The console’s zone status indicators
show four conditions for Zones 1–8.
49-2551AB.fm Page 27 Friday, February 19, 1999 3:41 PM