Filter
Top Products
17
MOUNTING ACCESSORIES
MOUNTING THE
WIRELESS SENSOR
TRANSMITTERS
You can install any combination of
wireless sensor transmitters (Cat. No.
49-2585) and motion detectors (Cat.
No. 49-2589), in up to 16 zones.
Follow these steps to mount each wire-
less sensor transmitter.
1. Set the
DELAY
switch on the
wireless sensor
transmitter to
MIN
to protect a win-
dow or to
MAX to
protect a door.
Note:
The
MAX
setting allows
you to arm a sen-
sor with a 60-
second exit delay
and a 30-second
entry delay (see
“Instant/Delay
Mode” on Page
26).
When set to
MIN, the sensor
immediately triggers the alarm
when a window opens, even if you
armed the system in the delay
mode.
2. Select a location for the wireless
sensor transmitter. We recom-
mend that you purchase enough
sensors to protect the front and
back door and any windows that
are hidden from view or easily
accessible (including basement
windows).
Note:
The supplied sensor and
magnetic switch are already con-
nected. If the wire is too long, you
can shorten it by cutting it to the
length required, stripping the
ends, and re-connecting it to the
magnetic switch.
3. Remove the sensor’s batteries
and attach it to the wall using the
supplied screws, or use double-
sided mounting tape (Cat. No. 64-
2361).
First attach the sensor’s back
cover to the wall, then slide the
sensor onto the cover. Replace
the batteries (if you removed
them) and close the battery com-
partment door.
4. Align the arrows on the switch and
magnet, and install the switch and
magnet using the supplied screws
or double-sided mounting tape.
49-2551AB.fm Page 17 Friday, February 19, 1999 3:41 PM