Filter
Top Products
26
OPERATION
ARMING/DISARMING
THE SYSTEM
You can arm the system three ways:
•Set
INSTALL/RUN 1/RUN 2 on the
console to
RUN 1 or RUN 2 and
press
ARM on the console.
•Set I
NSTALL/RUN 1/RUN 2 on the
console to
RUN 1 or RUN 2 and
press
ARM AWAY or ARM HOME
on the handheld remote control.
See “Arm Away/Arm Home” and
“Instant/Delay Mode.”
•Set
INSTALL/RUN 1/RUN 2 on the
console to
RUN 1 or RUN 2 and
press
ARM on the keychain
remote control.
The only difference between
RUN 1
and RUN 2 is that when the system is
set to
RUN 2 and
not
armed, the con-
sole sounds a pleasant chime when
you open a door or window. When it is
set to
RUN 1, there are no chimes.
The console beeps once when you
arm it. When the system is armed, the
RUN 1 and RUN 2 setting have the
same effect: opening a door or window
with a sensor attached or tripping a
motion detector sets off the alarm.
To disarm the system, press
DISARM
on any remote control. The console
beeps twice.
Arm Away/Arm Home
All wireless sensor transmitters and
motion detectors arm when you press
ARM AWAY on the handheld remote
control. If you press
ARM HOME, only
doors and windows arm. This lets you
arm the system at night without acci-
dentally tripping the motion detector(s)
yourself when you move around the
house.
Instant/Delay Mode
The ENTRY switch on the handheld re-
mote control lets you arm the system
with or without an exit/entry delay.
With
ENTRY on the handheld remote
set to
INSTANT (and DELAY on the sen-
sor(s) set to
MIN), the system instantly
arms and the alarm immediately trips if
a wireless sensor transmitter or motion
detector reports an intrusion.
With
ENTRY on the handheld remote
set to
DELAY, you have a 60-second
exit delay and a 30-second entry delay
before the system arms or trips. A
warning chime sounds during the de-
lay period.
49-2551AB.fm Page 26 Friday, February 19, 1999 3:41 PM