Filter
Top Products
Page 6
7063-173D
November 22, 2011
R
VOYAGEUR Wood Insert
1
Listing and Code Approvals
The Quadra-Fire VOYAGEUR meets the U.S. Environmental
Protection Agency’s 1990 particulate emission standards.
A. Appliance Certifi cation
C. Glass Specifi cations
D. BTU & Effi ciency Specifi cations
This stove is equipped with 5mm ceramic glass. Replace
glass only with 5mm ceramic glass. Please contact your
dealer for replacement glass.
B. Mobile Home Approved
EPA Certifi ed:
4.1 grams per hour
Effi ciency:
77%
BTU Output:
11,550 to 23,9300 per hr
Heating Capacity:
1,303 to 2,335 sq ft depend-
ing on climate zone
Vent Size:
6 inches
Firebox Size:
1.87 cubic feet
Max Wood Length:
18 inches
Fuel:
Cord Wood
Shipping Weight:
355 lbs
Model:
VOYAGEUR Wood Insert
Laboratory: Intertek
Report No:
100116597
Type:
Solid Fuel Type, Listed Room Heater
Standard: UL1482 and ULC S628-93 and
(UM) 84-HUD, Mobile Home
Approved.
NOTE: Hearth & Home Technologies, manufacturer of
this appliance, reserves the right to alter its products,
their specifi cations and/or price without notice.
NOTE: This installation must conform with local codes. In the
absence of local codes you must comply with the UL1482,
(UM) 84-HUD and NPFA211 in the U.S.A. and the ULC S628-
93 and CAN/CSA-B365 Installation Codes in Canada.
• This appliance is approved for mobile home installa-
tions when not installed in a sleeping room and when
an outside combustion air inlet is provided.
• The structural integrity of the mobile home fl oor, ceil-
ing, and walls must be maintained.
• The appliance must be properly grounded to the
frame of the mobile home with #8 copper ground
wire, and use only listed double-wall connector pipe.
• Outside Air Kit, part OAK-ACC must be installed in a
mobile home installation.
Improper installation, adjustment, alteration, service or
maintenance can cause injury or property damage.
For assistance or additional information, consult a qualifi ed
installer, service agency or your dealer.
Quadra-Fire is a registered trademark of Hearth & Home
Technologies.
• Installation and use of any damaged appliance.
• Modifi cation of the appliance.
• Installation other than as instructed by Hearth & Home
Technologies.
• Installation and/or use of any component part not approved
by Hearth & Home Technologies.
• Operating appliance without fully assembling all
components.
• Operating appliance without legs attached (if supplied with
unit).
• Do NOT Overfi re - If appliance or chimney connector glows,
you are overfi ring.
Any such action that may cause a fi re hazard.
WARNING
Fire Risk.
Hearth & Home Technologies disclaims any
responsibility for, and the warranty will be
voided by, the following actions:
Intertek Testing Laboratory is a National Recognized
Test Lab (NRTL) approved by OSHA.