Page 40
7063-173D
November 22, 2011
R
VOYAGEUR Wood Insert
A. Outside Air Kit Installation
Items Needed for Installation (not supplied)
• 4 inch fl ex aluminum pipe, or if using alternate material,
then it shall be made from durable, non-combustible, heat
resistant material up to 350
o
F. Cut the pipe to the required
length for your installation.
• Phillips head screw driver
• Silicone sealant
Figure 40.1
A source of air (oxygen) is necessary in order for combustion to
take place. Whatever combustion air is consumed by the fi re
must be replaced. Air is replaced via air leakage around win-
dows and under doors. In homes that have tightly sealed doors
and windows, an outside air source is needed. An optional Out-
side Air Kit is avail
able.
9
Appliance Set-up
WARNING
Do not draw outside combustion air from:
• Wall, fl oor or ceiling cavity
• Enclosed space such as an attic or garage
• Close proximity to exhaust vents or
chimneys
Fumes or odor may result
Fire Risk.
Asphyxiation Risk.
Asphyxiation Risk.
Length of outside air supply duct shall NOT exceed
the length of the vertical height of the exhaust fl ue.
• Fire will not burn properly
• Smoke spillage occurs when door is opened due
to air starvation.
WARNING
Option One - Outside Air Installation Instructions
1. Remove the outside air cover plate B on outer can and dis-
card
.
Figure 40.2.
2. Install optional fl ex adapter to outer can with the same
screws. Do not use plastic wire ties that come with the kit as
they will melt. NOTE: You may need to install the fl ex pipe
into the fi rebox fi rst depending on installation. Attach fl ex to
adapater with at least 2 screws.
3. Ensure existing access hole in fi replace is suffi cient to feed
the 4 inch fl ex.
4. After sliding can into fi replace, feed fl ex into cut opening to
obtain outside combustion air.
5. Level outer can and install appliance. See page 41.
Option Two - Outside Air Installation Instructions
1. Remove the outside air cover plate B on outer can and dis-
card and reuse the 4 screws.
2. Ensure existing acces hole in fi replace will not be covered by
the outer can. Existing outside air intake hole may be under
at the rear or side of outer can. Outside air may also enter
down existing chimney chase in some situations.
3. Repeat step 5 under Option One with one exception. After
installing the appliance in the outer can, seal the fi replace
opening and trim package with insulation to prevent air leak-
age into the room.
Outside air inlet must be located to prevent blockage from:
• Leaves, snow, ice or other debris
Block may cause combustion air starvation
Smoke spillage may set off alarms or irritate sensitive indi-
viduals.
WARNING
Asphyxiation Risk.
If Not Installing the Outside Air Kit
1. Swing grille down to expose the two screws. Figure 40.1
2. Remove the two screws and pull the access assembly
away from the appliance.
3. Remove the outside air cover plate A and discard.
4. Re-install the access assembly.
Grille hinges
downward
Remove Screws &
Pull Access Assembly
away from Insert
Remove Outside Cover
Plate A (Discard)
Outside Air Cover
Plate B (Discard)
Termination
Cap
Flex Adapter
Figure 40.2
Remove the zip tie to the lower
access cover. It is to prevent the
cover opening during shipping.