Filter
Top Products
November 22, 2011
7063-173D
Page 25
VOYAGEUR Wood Insert
R
G. Tube Channel Assembly Replacement
Figure 25.3
Removing Tube Channel Assembly
1. Remove the andirons and the right front brick cover.
2. Remove the 3 right side bricks.
3. Remove the baffl e protection channel by bending back the tabs
using needle nose pliers located at the right and left side of the
protection cover. Lift the cover up slightly and pull toward the
front and out of the fi rebox. Figure 25.1.
4. Locate the 2 channel nuts inside of chamber and remove using a
7/16 socket wrench. Figure 25.2.
NOTE: Soak the bolts with penetrating oil for at least 15 minutes
before trying to remove them.
5. Slide the tube channel assembly all the way to left until it is off the
threads. Drop the right side down, then slide the assembly back
to right. Figure 25.3.
6. The ceramic blanket and both baffl e boards can be removed at
the same time you remove the tube channel assembly.
7. When the tube channel assembly is free of the left side sup-
port, rotate clockwise and pull assembly, blanket and baffl es out
through the front opening.
8. Re-install in reverse order.
Baffle Protection
Channel
Bend Back Tabs
Use 7/16 Socket Wrench
and Remove Channel Nuts
Figure 25.1
Figure 25.2
Tube
Channel
Assembly
2 Tube Channel Nuts
Ceramic Blanket
Right Front
Brick Cover
Andirons
Baffle
Protection Channel
2 Baffle Boards
1
1
4