Filter
Top Products
November 22, 2011
7063-173D
Page 41
VOYAGEUR Wood Insert
R
C. Securing Stove Pipe/Liner to Flue Collar
1. There are 4 pre-drilled holes in the fl ue collar 90 degrees
apart. Attach the fl ue collar to the stove pipe/liner. If the
seal is questionable use stove mastic Figure 41.2.
2. Attach gasket to bottom side of fl ue collar with a thin coat
of silicone.
Flue Collar
Stove Pipe/Liner
Gasket
Figure 41.2
Remove 2 screws from both sides.
Adjust the legs up or down to level
appliance.
Figure 41.3
1. Remove the 2 screws already installed on each leg.
2. Move legs to the desired height.
3. Re-install the screws to secure in place.
D. Leveling Legs
B. Optional Elbow Flue Adapter Installation
Optional use of a Simpson Duravent 15° Universal Elbow
Part Number 4615 may be purchased directly through your
local Simpson Durvent Pipe Distributor or from your local
Quadra-Fire dealer, Part Number DV-4615.
Figure 41.1 shows a vertical installation and also how to
create an optional 30° elbow installation.
The 15° elbow may be secured directly to the fl ue collar.
Follow the pipe manufacturer’s instructions for using screws
or rivets for attachment. Most pipe manufacturer’s 6 inch
(152mm) diameter fl ue liners may be attached directly to
the top of the 15° elbow.
A
A
B
B
30 degree
Vertical
30
o
Figure 41.1
Flue
Adapter
A B
Vertical
13-9/16 in. (344mm) 20-15/16 in. (532mm)
30 Degree
14-5/8 in. (371mm) 20-11/16 in. (525mm)