Filter
Top Products
Page 42
7063-173D
November 22, 2011
R
VOYAGEUR Wood Insert
F. Standard Surround & Trim Kit Installation
Standard Size: 43 in. W x 31 in. H
Large Size: 51 in. W x 34 in. H
1. Lay surround face down on a protected surface to pre-
vent scratching.
2. Using a 4 to 6 inches long Phillips head screw driver
attach the side surrounds to the top surround using (2)
#8 sheet metal screws on each side provided with the kit.
Figure 42.2.
3. Lay the trim face down and place the corner brackets into
position.
4. Using a standard fl at screw driver tighten the corner
brackets. Figure 42.3.
5. Slide the assembled trim set over the surround set. and
then over the appliance matching the mounting tabs on
the side pieces with the slots on the appliance. Figure
42.2.
6. Align the 2 screws in the top surround piece to the 2
alignment holes on the appliance top. Secure in place.
Figure 42.2.
7. Use the strain relief in the surround side for blower cord
installation and use the cover plug to insert into the hole
where the blower cord is not installed.
Figure 42.2
Corner Brackets
Figure 42.3
E. Securing Appliance to Stove Pipe/Liner
1. Once you have the appliance in place and secured,
remove the tube channel assembly, baffl e board and
ceramic blanket. Detailed instructions are found on
pages 24 and 25.
2. Reach up through the fl ue opening and grab the attach-
ment bar and pull down inside fl ue opening. Figure
42.1.
3. Insert the 5/16 bolts inside the cast fl ue and through the
chimney mounting bar. Securely tighten the nuts. Fas-
teners are provided.
4. Re-install the tube channel assembly, baffl e board,
ceramic blanket and baffl e protection channel.
Figure 42.1
5/16 Nuts
Attachment
Bar
5/16 Bolts
Strain Relief for
Blower Cord and
Cover Plug for hole
in each side
Secure 2 Sides to Top
Mounting Tabs
Slide into Slots
on Firebox Face
Secure to
Firebox Face