Filter
Top Products
Page 24
7063-173D
November 22, 2011
R
VOYAGEUR Wood Insert
Figure 24.1
F. Baffl e & Ceramic Blanket Removal
1. Remove all ash from the fi rebox, and extinguish all hot
embers before disposal into a metal container.
2. It is easier to remove both baffl e boards and ceramic
blanket after the tube channel assembly has been partially
disassembled and the right side lowered. Follow steps
1 through 4 on page 25 for removal of the tube channel
assembly. It is not necessary to completely remove the
tube channel assembly.
3. Once the baffl e protection cover has been removed, pull
the baffl e boards and ceramic blanket forward about 1 inch
(25mm) and then overlap the baffl es about 1-2 inches (25-
51mm). Figure 24.2.
4. Slide the tube channel assembly to the left as far as it will
go and lower the right side. Remove the baffl e boards and
ceramic blanket together. Figure 24.3.
4. Re-install in reverse order. Be sure the baffl e boards and
ceramic blanket are in their proper positions. See Figure
12 .1 on page 12.
E. Door Handle Assembly
1. Install washer on door handle shaft.
2. Slide door handle through door.
3. Install additional washer(s) as shown in Figure 24.1.
4. Install key in groove.
5. Align groove in latch cam with key; slide latch cam over
shaft
6. Install locknut but do not overtighten, the handle needs
to move smoothly.
7. Install handle turning in a counter-clockwise motion to
desired location on door handle rod. Figure 24.1.
CAUTION! Do not overtighten lock nut. The door handle
needs to move smoothly.
Locknut
Latch Cam
Spacing
Washers
Door Cross
Section
Square Key
Door Handle Shaft
Fiber Handle
Figure 24.2
Figure 24.3
Slide Tube Channel to the
Left and Lower Right Side
Baffle Boards Overlapping
Ceramic Blanket