Filter
Top Products
68 C3434M-A (9/07)
EDIT EVENT LABEL
After an event has been programmed, the label can be changed using the following steps:
1. Use the joystick to position the cursor beside EDIT EVENT LABEL.
2. Press Iris Open. The following appears on the monitor:
3. Use the joystick to position the cursor beside a character. Press Iris Open to enter selection.
To clear a character, position the cursor beside BACKSPACE, and then press Iris Open.
4. When label is completed, move the cursor to OK. Press Iris Open to return to the Edit
Schedule menu.
After an event has been labeled, the label will be displayed when the event is activated
according to the display setup values for this label. Refer to the Display Setup section on page 28
for instructions on how to change the way a label is displayed on the monitor.
EXIT
PELCO SPECTRA IV SE HORIZON
LANGUAGE
<SYSTEM INFORMATION>
<DISPLAY SETUP>
<DOME SETTINGS>
RESET CAMERA
CYCLE CAMERA POWER
REBOOT SYSTEM
BACK
EXIT
<CAMERA>
<MOTION>
<POWER UP>
<LINE SYNC>
<PRESETS>
<PATTERNS>
<ZONES>
<WINDOW BLANKING>
<ALARMS>
<AUX>
<TITLE TEXT>
<CLEAR>
<PASSWORD>
<CLOCK>
<EVENT>
DOME SETTINGS
EVENT
EVENT TYPE
EVENT LABEL
<EDIT EVENT LABEL>
<EDIT EVENT>
<CLEAR EVENT>
<LIST EVENT>
HOLIDAY
<EDIT HOLIDAY>
<CLEAR HOLIDAY>
<LIST HOLIDAYS>
BACK
EXIT
REFERENCE INFORMATION
12:00 AM NONE
EDIT EVENT LABEL
EVENT 1
1234567890 OK
ABCDEFGHIJ CANCEL
KLMNOPQRST
UVWXY.,-/ SPACE
abcdefghij BACKSPACE
klmnopqrst
uvwxyz#&:*