Filter
Top Products
28 C3434M-A (9/07)
Display Setup
Display setup allows you to program how labels are displayed on the monitor. The following
labels are available:
PRESET LABEL Identifies preset.
ZONE LABEL Identifies zone.
ZOOM Identifies the amount of magnification.
AZIMUTH
1
/ELEVATION
2
Amount of pan from zero degrees vertical and the amount of tilt
from zero degrees horizontal.
DIRECTION Displays compass direction.
ALARM MESSAGE Displays activated alarm.
DATE/TIME Displays current date and time.
EVENT LABEL Displays activated event.
A preset label is displayed when a preset is called. A zone label is displayed when the system
moves into a zone. The zoom ratio label is displayed when zoom is activated. Azimuth/elevation
and direction labels are displayed when pan/tilt is activated. An alarm message appears on the
monitor when an alarm occurs. An event label appears on the monitor when an event occurs.
The following settings are available for each label except date and time:
OFF Label is not displayed when activated.
CONSTANT The label is continually displayed when activated.
2 SECONDS The label is displayed for 2 seconds after activation.
5 SECONDS The label is displayed for 5 seconds after activation.
10 SECONDS The label is displayed for 10 seconds after activation.
The settings for date and time are ON or OFF.
1
Azimuth is the pan angle from zero to 359 degrees.
2
Elevation is the tilt position from 18 to -90 degrees.
EXIT
PELCO SPECTRA IV SE HORIZON
LANGUAGE
<SYSTEM INFORMATION>
<DISPLAY SETUP>
<DOME SETTINGS>
RESET CAMERA
CYCLE CAMERA POWER
REBOOT SYSTEM
BACK
EXIT
PRESET LABEL
ZONE LABEL
ZOOM
AZIMUTH/ELEVATION
DIRECTION
ALARM MESSAGE
DATE/TIME
<LABEL POSITIONS>
RESTORE FACTORY DEFAULTS
DISPLAY SETUP